![]() ![]() Loosen the nut with an open end wrench turning clockwise. To install a new bit, place the 5 collet into the nut. Then put the bit into the nut and collet. 6 12 Lock the bit with an open end wrench turning counterclockwise.Ĭutting Tools Conical Bit Tool Model No. Flute length: 0.47”/ Cut depth: Max 0.45”.381044-000 Ĭutting Tools (cont.) End Mill Bit Tool model No. Installing i-Picture Software (Recommended Operating System – Windows XP, Vista or 7) When you purchase the intelliCarve, it comes with i-Picture software. i-Picture converts your image files (gif, png, bmp & jpg) to a. Gee file in order for intelliCarve to perform. To begin using i-Picture software it first must be loaded into your personal computer. #IPICTURE FOR INTELLICARVE 1013 SOFTWARE# Settings Unit: or measurement Size of Project is the carving size that you wish to appear on your workpiece. The boxes represent X/Y/Z = width/length/depth of cut. ![]() When you input a number in X, Y will be set automatically according to the ratio of your image. Similarly, when you input a number in Y, X will The maximum allowable dimensions are X=13”(330.2mm), or Y=18”(457.2mm) and Z=3”(76.2mm). Settings (cont.) XY Origin Position represents your picture and how it will be oriented on your work piece. (However this will ultimately be determined when you set the spindle to your preferred starting point on the work piece, but this will be discussed later in section 7.) If using a single piece of material for one carving it may be advantageous to start in the center as this is an easy point to find on your material. #IPICTURE FOR INTELLICARVE 1013 WINDOWS#.#IPICTURE FOR INTELLICARVE 1013 SOFTWARE#.#IPICTURE FOR INTELLICARVE 1013 MANUAL#.#IPICTURE FOR INTELLICARVE 1013 INSTALL#.
0 Comments
Leave a Reply. |